Proper breeding ground for germanene
Graphene may currently be the best known 'two dimensional' material, its new cousin germanene seems to have properties that are even more attractive for application in electronics. For this, germanene has to grow in a one atom layer on top of a proper carrier - substrate. Scientists of the MESA+ Institute for Nanotechnology of the University of Twente and of the Radboud University managed to grow germanene on a semiconductor material, preserving the unique properties. In two separate papers in the same edition of Physical Review Letters, they present calculations and experiments.
Germanene is a one atom thick sheet of germanium, in a honeycomb structure. It has clear similarities with graphene, the material that induced massive research activity worldwide, especially after 2010's Nobel Prize. A major difference between graphene and germanene is the 'band gap', a property well-known in semiconductor electronics: thanks to this 'jump' of energy levels that electrons are allowed to have, it is possible to control, switch and amplify currents. Graphene had a very small band gap that can only be measured at very low temperatures, germanene shows a band gap that is significantly larger. Previous attempts to grow germanene, however, show that these attractive properties seem to vanish when it is grown on a metal surface: a good conductor of current. To prevent this, the scientists chose the semiconductor MoS2 as the substrate material.
Islands
Under ultra-high vacuum conditions, germanene indeed grows on the semiconductor. At first, the scientists observed islands at the locations where MoS2 had crystal defects, after that the germanene is spreading out covering a larger surface. An exciting question is, if the desired properties remain intact. First measurements show that the typical 2D properties and band gap are present, further low temperature measurements are needed to confirm that germanene operates in the desired way: the inner part would work as an insulator, while conducting channels are formed at the edges. Other scientists did quantum mechanical calculations on the molybdenum-disulfide combination. They, for example, looked at the direction of growth, to be able to optimize the process. The theoretical group went one step further, by not only investigating the bilayer of molybdenum-disulfide, but als covering the germane with molybdeendisulfide. This prevents germanene from rapid oxidation. Calculations show that the sandwich construction has even better performance when it comes to the band gap.
Spintronics
Both publications show dat germanene, grown on molybdenum-disulfide is an important first step towards new electronic devices or unsuspected combinations with conventional devices. 'Spintronics', based on the spin movement of electrons, seems to be an attractive application area for germanene. Electrons with spin up and electrons with spin down have separate conducting channels on the edges of germanene.
This work is part of the following Vrije FOM-programma: '2D semiconductor crystals'.
References
Publication from the Harold Zandvliet group (UT) and the Misha Katsnelson group (RU):
Structural and electronic properties of germanene on MoS2 , Phys. Rev. Lett. 116, 256804, 21 June 2016.
Publication from the Paul Kelly group (UT):
Z2 invariance of germanene on MoS2 from first principles , Phys. Rev. Lett. 116, 256805 – 21 June 2016